Alpine NVE-N872A Hardware Manual - Page 12

Before Using This System Precautions for the remote control a This device is lightweight and compact. Do not drop it or bump it. Do not put it in your trousers pocket. Doing so could break it, speed up battery wear, or cause malfunction. a To clean this device, wipe it off with a dry cloth. (If it is extremely dirty, wipe it off with a Tips damp cloth that has been carefully wrung out.) Never use benzene, paint thinner or harsh chemicals. They cause deterioration of the case and paint. Do not leave this remote control on the dashboard or anywhere else subject to direct sunlight. Replacing the batteries Use two AAA-type batteries. 1 2 Open the cover Replace the batteries 3 Close the cover Opening the battery cover. Push on the cover and slide it as indicated by the arrows then the cover will be removed. Replacing the battery. Remove the old batteries. Insert new ones matching the (+) and (-) polarities as shown in the diagram inside the remote control. Closing the cover. Push the cover in the arrow direction until a click is heard. Remote Control Holder Installation • If direct sunlight reaches the remote control mounted on the holder, remove the remote Remote Control control from the holder and put it in the Holder glove compartment. • If double-sided adhesive tape cannot install Double-Sided the holder securely, use screws. Adhesive Tape (Before attaching the tape, make Note: Attach the blue protective paper side sure the mounting locations are of double-sided tape onto the console free from dust or box, etc. dirt) Protective Paper Remote Control Reinforcing Screws Console Box etc. 12