Alpine PKG-RSE3HDMI Instruction Manual - Page 4

Optional Mounting Bracket M4 Tapping Screws (Not included: screw length depends on vehicle) Roof Support 5 Install the rear interchangeable color cover. Align the openings on the cover with the rear button panel. Press down firmly to snap the cover into place. Ensure that all notches have gone into their grooves properly. Vehicle Roof Headliner M4 x 13 Machined Screws (4) (Included) Install trim ring before attaching the overhead monitor to the metal installation bracket. Removing Interchangeable Color Cover 1 Remove the rear interchangeable color cover. Reach across the monitor body and grasp the rear panel. Gently lift the panel until it snaps off from the body. The trim ring is used to make the monitor sit flush against the ceiling contour. Ask ALPINE dealer for detail. Screw the shroud to the monitor body using the provided screws. 4 Install the overhead monitor to the ceiling. Connect the cables and then install 4 screws to the metal installation bracket. Rear screw holes 2 Remove both side panels of the interchangeable color covers. Grasp side cover as illustrated. Raise the corner touching the rear control panel a few millimeters and gently slide the cover out. Do not immediately lift the cover before sliding it. The notches will be damaged. A small flat screwdriver or similar tool can be used to raise the corner of the panel. Front screw holes (underneath LCD screen) (Left rear screw not illustrated) 4-EN