Alpine PSU-300MTG Installation Manual - Page 6

Installation

Get Alpine PSU-300MTG PDF manuals and user guides View all Alpine PSU-300MTG manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Ford Mustang ˜ 6/12 Installation 1 Connect the power cable to the Positive (+) battery terminal and route it through the passenger side firewall. Note: The negative terminal should remain disconnected unit the installation is completed. 2 Route the power cable thru the rubber grommet on the firewall on the passenger side foot well. 3 Locate (2) hole openings below the globe box and enlarge them to 1/2"using a step drill. 4 Release the globe box compartment by pressing the side tabs towards each other and releasing the shock on the right side. 5 Remove (2) 8mm screws from the lower glove box compartment cavity and attach the (2) hook mounting clips using the same screws. 6 In some cases the clips may need to be opened slightly to allow sliding into place.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
Ford Mustang
±
6/12
Installation
1
Connect the power cable to the
Positive (+)
battery
terminal and route it through the passenger side
firewall.
Note: The negative terminal should remain
disconnected unit the installation is completed.
3
Locate (2) hole openings below the globe box and
enlarge them to 1/2”using a step drill.
5
Remove (2) 8mm screws from the lower glove
box compartment cavity and attach the (2) hook
mounting clips using the same screws.
2
Route the power cable thru the rubber grommet on
the firewall on the passenger side foot well.
4
Release the globe box compartment by pressing
the side tabs towards each other and releasing the
shock on the right side.
6
In some cases the clips may need to be opened
slightly to allow sliding into place.