Alpine S2-A60M Owners Manual - Page 9
Cautions on wire lead connections
View all Alpine S2-A60M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Cautions on wire lead connections When using third-party wire cables (power supply wire), use the supplied screws to simplify the connection. Refer to the description below for the proper procedure. If you are in doubt about how to make this connection, consult your dealer. 1. Check the wire size. • For details on the wires size to be used, refer to the supplied "Cautions on Power Supply Wires Connection" and "Cautions on Power Supply Wires" (page 15), and then use the wire of the specified size. • If the wire gauge used is unknown, ask your dealer. 2. Remove the insulation from the ends of the wire leads by about 7 - 10 mm (9/32" - 13/32"). 7 - 10 mm (9/32" - 13/32") Lead end side of the product Twist the tip of wire leads NOTES: • If length of the exposed wire is too short, a poor connection may occur causing operation failure or sound interruption. • On the other hand, if the length is too long, an electrical short-circuit may occur. 3. Tighten the hexagon hole screw with the hexagon wrench (included) to secure the lead. Before making this connection, use insulated shrink tubing to cover any exposed wire extending beyond the terminal. Power Supply Terminal Hexagon Wrench (included) Speaker Output Terminals Hexagon Wrench (included) Hexagon hole screw Speaker Output Terminals Speaker Output Lead (+) Speaker Output Lead (-) (e.g. S2-A60M) NOTES: • Be sure to use the Hexagon hole screw attached to the Power Supply Terminal ( ) or Speaker Output Terminals ( ). • For safety reasons, connect the battery leads last. • To prevent disconnection of the leads or dropping of the unit, do not use the cabling to carry the unit. Hexagon hole screw Battery Lead Ground Lead Remote Turn-On Lead Power Supply Terminal (e.g. S2-A60M) 7-EN