Amana ADB1500ADS Use & Care Guide - Page 8

Control Lock OPTIONS CAN BE SELECTED WITH WHAT IT DOES ADDED TIME TO CYCLE ADDED WATER GALLONS (LITERS) Raises water temperature to improve cleaning for loads containing tough, baked-on food. SoilSense Heavy Normal Soak & Prewash Raises the main wash temperature to 135°F (57°C) 0:05 to 0:13 0 - 3.9 (0 - 14.6) Dries dishes with heat. This option, with the use of SoilSense Uses a heating 0:08 to 0:46 0 rinse aid, will provide the best drying results. Heavy element to speed Plastic items are less likely to deform when loaded Normal drying times. Heated in the top rack. Use Heated Dry for optimum 1 Hour Dry option defaults to drying performance or turn the Heated Dry option Soak & On when any cycle is off for air dry. Prewash selected except for 1 Hour Wash and Eco. Turns the heating element on at the end of the wash portion of the cycle. Its shorter heating time uses significantly less energy compared to using Heated Dry. Available with any cycle 0:11 0 Runs dishwasher at a later time. Select a wash cycle and options. Each time you press the delay button it will display the next available delay time. Press DELAY. Press START/RESUME. Close door firmly. Available with any cycle Delays start of a cycle up to 24 hours. NOTE: The dishwasher remembers the last Delay you selected. To reset the delay time to something other than what is displayed, continue to press the Delay button until the desired delay time is reached. NOTE: Anytime the door is opened (such as, to add a dish); START/RESUME must be pressed again to resume delay countdown. Avoids unintended use of dishwasher between cycles, or cycle and option changes during a cycle. To turn on Control Lock, press and hold SANI RINSE for 3 seconds. Control Lock light will stay on for a short time, indicating that it is activated. When the Lock indicator is lit all buttons are disabled. If you press any button while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked. To turn off Control Lock, press and hold SANI RINSE for 3 seconds. Control Lock light turns off. *Maximum Water added with any combination of options is 4.8 gallons (18.2L). Control Purpose Comments Press to start or resume If the door is opened during a cycle or the power is interrupted, the Start/Resume a wash cycle. button LED flashes. Cycle will not resume until door is closed and START/ RESUME is pressed. Press to cancel wash cycle. Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely. To follow progress of your The Clean or Complete indicators will glow when a cycle is finished. (Depending dishwasher cycle. on your model.) NOTE: Indicators shown If you select the Sani Rinse option, when the cycle is finished, the "Sanitized" are not available on all indicator glows. If your dishwasher did not properly sanitize your dishes, the light models. flashes at the end of the cycle. This can happen if the cycle is interrupted, or water could not be heated to required temperature. The light goes off when you open and close the door or press CANCEL. 8