Amana AGR4433XDB Installation Instruction - Page 7
Install Anti-Tip Bracket
UPC - 883049206387
View all Amana AGR4433XDB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
WARNING Install Anti-Tip Bracket 6. Align the anti-tip bracket holes with the holes in the floor. Fasten the anti-tip bracket with the screws provided. Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. Contact a qualified floor covering installer for the best procedure for drilling mounting holes through your type of floor covering. Before moving range, slide range onto shipping base, cardboard or hardboard. 1. Remove template from the anti-tip bracket kit (found inside the oven cavity). 2. Place template on the floor in cabinet opening so that the left edge is against cabinet and top edge is against rear wall, molding or cabinet. 3. Tape template into place. 4. If countertop is not flush with cabinet opening edge, align template with overhang. Depending on the thickness of your flooring, longer screws may be necessary to anchor the bracket to the subfloor. Longer screws are available from your local hardware store. 7. Move range close enough to the opening to allow for final electrical connection. Remove shipping base, cardboard or hardboard from under range. 8. Open the broiler door. Use a ³⁄₈" drive ratchet to lower the rear leveling legs one-half turn. Use a wrench or pliers to lower the front leveling legs one-half turn. B A A Rear leveling leg A. Rear leveling leg B. Front leveling leg 9. Adjust the leveling legs to the correct height. Leveling legs can be loosened to add up to a maximum of 1" (2.5 cm). A minimum of 0.5 cm) is needed to engage the anti-tip bracket. 10. Move range into its final location, making sure rear leveling leg slides into anti-tip bracket. If cabinet opening is wider than that specified in the "Location Requirements" section, adjust template so range will be centered in cabinet opening. 5. To mount anti-tip bracket to wood floor, drill two ¹⁄₈" (0.32 cm) holes at the positions marked on the bracket template. Remove template from floor and move to Step 6. To mount the anti-tip bracket to a concrete or ceramic floor, use a 0.5 cm) masonry drill bit to drill 2 holes at the positions marked on the bracket template. Remove the template from the floor. Tap plastic anchors into holes with a hammer. 11. If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the "Location Requirements" section. 12. Continue installing your range using the following installation instructions. 7