Amana AGR5330BAB Installation Guide - Page 9
Verify Anti-Tip Bracket Is Installed, and Engaged
View all Amana AGR5330BAB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Complete Connection 1. Locate gas pressure regulator in the back of the range. 5. Remove cooktop burner caps and grates from parts package. Align notches in burner caps with pins in burner base. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light. Place burners, burner caps and grates on the cooktop. WARNING A A. Gas pressure regulator IMPORTANT: Do not remove the gas pressure regulator. 2. Check that the gas pressure regulator shut-off valve is in the ON position. A B A. ON position B. OFF position IMPORTANT: The factory default setting is the ON position. If the range does not work, verify that the valve is in the ON position. 3. Open the manual shut-off valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. A B Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 6. Plug into a grounded 3 prong outlet. Verify Anti-Tip Bracket Is Installed and Engaged 1. Place the outside of your foot against the bottom front of the broiler and grasp the lower right or left side of the control panel as shown. NOTE: If your countertop is mounted with a backsplash, it may be necessary to grasp the range higher than is shown in the illustration. A. Closed valve B. Open valve 4. Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leak found. 2. Slowly attempt to tilt the range forward. If you encounter immediate resistance, the range foot is engaged in the anti-tip bracket. 9