Amana AGR5330BAW Installation Guide - Page 3
Installation Requirements
View all Amana AGR5330BAW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
In the State of Massachusetts, the following installation instructions apply: I Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts. I If using a ball valve, it shall be a T-handle type. I A flexible gas connector, when used, must not exceed 3 feet. Range Foot WARNING Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. Anti-Tip Bracket To verify the anti-tip bracket is installed and engaged: • Slide range forward. • Look for the anti-tip bracket securely attached to floor or wall. • Slide range back so rear range foot is under anti-tip bracket. • See installation instructions for details. INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Parts supplied Read and follow the instructions provided with any tools listed here. Check that all parts are included. Tools needed A ■■ Tape measure ■■ Marker or pencil ■■ Flat-blade screwdriver ■■ Pipe-joint compound B ■■ Phillips screwdriver resistant to LP gas ■■ Level ■■ Noncorrosive leak-detection solution ■■ Hand or electric drill For LP/Natural Gas ■■ Wrench or pliers Conversions ■■ Pipe wrench ■■ ¹5⁄16" (2.4 cm) combination wrench ■■ ¼" (6 mm) drive ratchet ■■ ³⁄8" (1 cm) nut driver ■■ ³⁄8" (1 cm) combination wrench ■■ ½" (1.3 cm) combination wrench ■■ 5⁄8" (1.6 cm) combination wrench ■■ ¹⁄8" (3 mm) drill bit (for wood ■■ floors) 7 mm (9⁄32") combination wrench ■■ Quadrex®† or Phillips screwdriver ■■ Masking tape A. Anti-tip bracket B. #12 x 15⁄8" (4.1 cm) screws (2) ■■ Literature bag ■■ Conversion orifice spuds (inside bag containing literature) ■■ Anti-tip bracket must be securely mounted to floor or wall. Thickness of flooring may require longer screws to anchor bracket to floor. Parts needed Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See "Electrical Requirements" and "Gas Supply Requirements" sections. †® QUADREX is a registered trademark of NLW Holdings, Inc. 3