Amana ASI2175GRS Installation Instructions - Page 16
tightened. See the Connect Water Supply
View all Amana ASI2175GRS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
ICE AND WATER Possible Causes and/or Recommended Solutions Water is leaking or dripping from the dispenser NOTE: After dispensing, a few additional drops of water are normal. ■■ Glass was not held under the dispenser long enough - Hold the glass under the dispenser for 2 to 3 seconds after releasing the dispenser pad/lever. ■■ New installation, or water filter was recently installed or replaced - Air in the water lines causes the water dispenser to drip. Flush the water system to remove the air in the water lines. See the "Water and Ice Dispensers" section. ■■ Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or pieces. Water is leaking from the back ■■ Water line connections are not fully tightened - Make sure all connections are firmly of the refrigerator tightened. See the "Connect Water Supply" section. Water from the dispenser is not cool enough (on some models) NOTE: Water from the dispenser is chilled to 50°F (10°C). ■■ New installation - Allow 24 hours after installation for the water supply to cool completely. ■■ Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool completely. ■■ Water has not been recently dispensed - The first glass of water may not be cool. Discard the first glass of water dispensed. ■■ Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold water pipe. See the "Water Supply Requirements" section. 16