Amana NED5700B Installation Instruction - Page 23
Remove door from dryer, Move the door strike, Remove inner door from, outer door, Reinstall door
![]() |
View all Amana NED5700B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
7. Reinstall door on dryer 2. Move the door strike Using a TORX® T25® screwdriver, remove the 4 screws on the dryer. Insert the tabs on the hinge into the mounting slot and slide down to engage the top tab. Secure in place with the 4 TORX® T25® screws removed earlier. Reverse door swing square-shaped door 1. Remove door from dryer Using a TORX® T25® screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Remove the 4 screws above and below the door strike and set aside for later use. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown. 3. Remove inner door from outer door Release tab Using a TORX® T25® screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Retain or set aside the 4 screws. Release tab Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 13 screws securing the inner door to the outer door. Lift off the inner door and set aside. NOTE: There is a small release tab on each side of the door. If the inner and outer door do not separate easily, slide a credit card, putty knife, or similar flat object between the inner and outer doors at the locations shown to release the tab. 23
![](/manual_guide/products/amana-ned5700b-installation-instruction-71d42be/23.png)