Amana NED7300WW Installation Instruction - Page 8
Electrical Connection, Power Supply, Cord Connection
UPC - 883049162324
View all Amana NED7300WW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Electrical Connection Power Supply Cord 2. Remove terminal block cover Electrical Connection Options 1. Choose electrical connection type Power supply cord 4-wire receptacle (NEMA Type 14-30R): Go to Power Supply Cord Connection. Power supply cord 3-wire receptacle (NEMA Type 10-30R): Go to Power Supply Cord Connection. 4-wire direct connection: Go to Direct Wire Connection. 3-wire direct connection: Go to Direct Wire Connection. NOTE: If local codes do not permit connection of a cabinet-ground conductor to neutral wire, go to "Optional 3-wire connection." This connection may be used with either a power supply cord or a direct wire connection. Before you start, disconnect power. Remove hold-down screw and terminal block cover. Power Supply Cord Connection Power supply cord strain relief: 1. Attach power supply cord strain relief A B C D Remove the screws from a 3/4" (19 mm) UL listed strain relief (UL marking on strain relief). Put the tabs of the two clamp sections (C) into the hole below the terminal block opening (B) so that one tab is pointing up (A) and the other is pointing down (D), and hold in place. Tighten strain relief screws just enough to hold the two clamp sections (C) together. 8