Amana NTW4630Y Use and Care - Page 11
detergent. Close lid and press START/Pause/Unlock Lid.
View all Amana NTW4630Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
TROUBLESHOOTING First try the solutions suggested here or visit our website at www.amana.custhelp.com In Canada www.amanacanada.ca for assistance and to possibly avoid a service call If you experience Possible Causes Solution Water Leaks Check the following for proper installation: Washer not level. Water may splash off basket if washer is not level. Check that load is not unbalanced or tightly packed. Fill hoses not attached tightly. Tighten fill-hose connection. Fill hose washers. Make sure all four fill hose flat washers are properly seated. Drain hose connection. Pull drain hose from washer cabinet and properly secure it to drainpipe or laundry tub. Do not place tape over drain opening. Check household plumbing for leaks or clogged sink or drain. Water can back up out of a clogged sink or drainpipe. Check all household plumbing for leaks (laundry tubs, drain pipe, water pipes, and faucets.) Washer not loaded as recommended. Improper loading can cause basket to be out of alignment and cause water to splash off tub. See "Using Your Washer" for loading instructions. Washer not performing as expected Washer won't run or fill, washer stops working or wash light remains on (indicating that the washer was unable to fill appropriately) Check for proper water supply. Both hoses must be attached and have water flowing to inlet valve. Both hot and cold water faucets must be turned on. Check that inlet valve screens have not become clogged. Check for any kinks in inlet hoses, which can restrict water flow. WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Check proper electrical supply. Normal washer operation. Washer may be tightly packed. Plug power cord into a grounded 3 prong outlet. Do not use an extension cord. Ensure there is power to outlet. Reset a tripped circuit breaker. Replace any blown fuses. NOTE: If problems continue, contact an electrician. Lid must be closed for washer to run. Washer will pause during certain phases of cycle. Do not interrupt cycle. Remove several items, rearrange load evenly in basket, and add detergent. Close lid and press START/Pause/Unlock Lid. Add only 1 or 2 additional garments after washer has started. 11