Antec Minuet 350 Manual - Page 4

CONNECTING THE USB PORTS You will find a single 10-pin connector on a cable attached to the front USB ports. This Intel standard connector is keyed so that it can't be accidentally reversed as long as it is connected to a proper Intel standard motherboard header. Connect the 10-pin connector to your motherboard headers so that the blocked pin fits over the missing header pin. Motherboard USB Pin Layout 12 Pin Signal Names Pin Signal Names 1 USB Power 1 2 USB Power 2 3 Negative Signal 1 4 Negative Signal 2 5 Positive Signal 1 6 Positive Signal 2 7 Ground 1 8 Ground 2 9 10 9 Key (No Connection) 10 Empty Pin Note: Please check your motherboard manual for your USB header pin layout and make sure it matches the table. CONNECTING THE eSATA PORT This case comes with an eSATA port in the front of the case to connect to your external SATA devices. You will find a SATA connector on a cable attached to the front eSATA ports. Connect it to a SATA connector on your motherboard. CONNECTING THE AUDIO PORTS (AC'97 and HDA) There is an Intel standard 10-pin AC'97 connector and an Intel 10-pin HDA (High Definition Audio) connector. You can connect either of them to your motherboard depending on the specification of the motherboard. See instruction below: Note: Please check your motherboard manual for your audio header pin layout and make sure it matches the table below. Even if your system supports both audio standards, you may only connect one connector not both. Pin Assignment for Audio Ports (HDA and AC'97) 10 6 4 2 97531 Pin Signal Names (HDA) Pin Signal Names (AC'97) 1 MIC2 L 1 MIC In 2 AGND 2 GND 3 MIC2 R 3 MIC Power 4 AVCC 4 NC 5 FRO-R 5 Line Out (R) 6 MIC2_JD 6 Line Out (R) 7 F_IO_SEN 7 NC 8 Key (no pin) 8 Key (no pin) 9 FRO-L 9 Line Out (L) 10 LINE2_JD 10 Line Out (L) 3