Ariens Ariens Razor Push Owners Manual - Page 17

MAINTENANCE CAUTION: AVOID INJURY. Read and understand the entire Safety section before proceeding. Ariens Dealers will provide any service, parts or adjustments which may be required to keep your unit operating at peak efficiency. Should engine require service, contact an Ariens Dealer or an authorized engine manufacturer's service center. MAINTENANCE SCHEDULE CHECK ENGINE/BLADE CONTROL The engine and blade must stop within 3 seconds after releasing the engine/blade control. If the engine and blade continue to run, adjust or repair control immediately. CHECK WHEEL DRIVE CONTROL The unit must stop quickly and completely when the control is released. Adjust or repair if necessary. See WHEEL DRIVE CONTROL ADJUSTMENT on page 23. NOTICE: Some working conditions (heavy loads, high ambient temperatures, dusty conditions, or airborne debris) may require more frequent service. See engine manual for further maintenance and troubleshooting information. CHECK GRASS BAG Check grass bag frequently for wear or deterioration. Replace worn or damaged bag with Ariens original equipment replacement bag only. MAINTENANCE SCHEDULE Before 25 100 Service Performed Each Use Check Engine/Blade • Control Check Wheel Drive • Control Check Grass Bag • Clean Unit • Check Engine Oil • Check Mower Blade • Check Drive Belt • Check Fasteners • Check Air Cleaner • Change Engine Oil General Lubrication *• • Check Spark Plug • Check Engine • Cooling Check Muffler • * After first 5 Hours of operation. CLEAN UNIT Before each use clean unit, muffler and engine surfaces of debris, oil or fuel spills to ensure proper cooling and prevent fires. Clean unit of all dirt and debris. Do not use solvents, hard cleaners, or abrasives. NOTICE: Protect painted surfaces with automotive type wax. IMPORTANT: Do not spray the unit with water, especially when the unit is warm from operation. CHECK ENGINE OIL IMPORTANT: Maintain proper oil level at all times or engine damage will result. Check the level of the engine crankcase oil before each use. Make sure engine is level when checking oil. See engine manual for instructions. CHECK MOWER BLADE See Figure 12. Check blade mounting: blade must be secure and bolt torqued to 37.5 - 50 lbf-ft (51 - 68 N•m) (bolt should fully compress lock washer). Check blade for nicks and dull cutting edges. Sharpen if necessary. Check blade for rounded or broken ends, thinned metal or other damage. Replace if necessary. EN - 17