Ariens Deluxe 24 Owners Manual - Page 14
Check Function of all Controls - spark plug
View all Ariens Deluxe 24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Install Skid Shoes (921029, 032) (Figure 16) 1. Remove hardware from skid shoes. 2. Install hardware through blower housing and skid shoe as shown. 3. Adjust skid shoes (see Skid Shoes on page 27). 1 2 3 4 1. Bolt, Round Head Square Neck .38-16 x 1.00 2. Skid Shoe, Reversible 3. Washer, Flat Steel .438 x 1.00 x .083 4. Nut, Locking, Center, .38-16 Figure 16 Check Function of Dual Handle Interlock Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If they do not, contact your Dealer for repairs. Check Tire Pressure (921024, 028, 029, 030, 032, 035) Check tire pressure and adjust to the pressure listed on tire sidewall. CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly: • Do not attempt to mount a tire without the proper equipment and experience to perform the job. • Do not inflate the tires above the recommended pressure. • Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel. • Do not stand in front or over the tire assembly when inflating. Use a clip-on chuck and extension hose long enough to allow you to stand to one side. Check Track Tension (921023) Check tracking of unit and tension the tracks as required (see Track Tension Adjustment on page 34). Check Auger Gearcase Oil Check oil level in auger gearcase (see Check Auger Gearcase on page 25). Check Engine Crankcase Oil IMPORTANT: The engine may be shipped with oil in crankcase. Refer to Engine Manual for detailed instructions. Fill Engine Fuel Tank Fill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK on page 20 If Applicable - remove the protective wrap from the fuel tank and install the fuel cap located in the attached bag. Check Function of all Controls Ensure unit runs and performs properly. Refer to OPERATION on page 17. Run-in Attachment Belt 1. Start unit in a well-ventilated area according to Starting and Shut Off on page 22. 2. Engage attachment clutch lever and run attachment for about 15 minutes. 3. Stop unit, wait for all moving parts to stop, and remove spark plug wire. 4. Adjust clutch idler according to Attachment Clutch/Brake Adjustment on page 29. 5. Adjust belt finger, if necessary. See Check Belt Finger Clearance on page 31. EN - 14