Ariens Max Zoom 60 Operation Manual - Page 16

Parking, Moving The, Unit With The, Engine Off, For Best Performance, Important - inch

Page 16 highlights

WARNING: Move the steering control levers slowly and keep the throttle control lever at slow speed until you learn how to operate the unit. 3. Bring the steering levers to neutral. 4. Slow the engine down to about 3/4 speed. 5. Turn ON the PTO switch to engage the mower. IMPORTANT: Never engage the PTO if the mower is plugged with grass or other material. This may cause damage to the electric clutch. 6. Move throttle control to fast. 7. Move the steering levers forward to obtain a slow ground speed. 8. To disengage the mower, move the PTO switch to the "Off" position. 9. When you know how to operate the unit, select a speed appropriate to your mowing conditions. PARKING To park the unit: 1. Bring the steering levers to neutral. Turn off PTO. 2. Move the throttle lever to the "Slow" position. 3. Engage the parking brake. 4. Lower the attachment. 5. Turn the ignition key to the "Off" position and remove the key. MOVING THE UNIT WITH THE ENGINE OFF IMPORTANT: Never tow unit. 1. Shut OFF engine. 2. Place seat in the service position (See Service Position on page 18). 3. Pull the right and left bypass levers to the neutral position. WARNING: Do not bypass transmission when on a slope. 4. Disengage parking brake. 5. Push unit to desired location. 6. Engage parking brake. 7. Push the right and left bypass levers to the drive position. Push Lever In to Drive Position Pull Lever Out to the Neutral Position OF4105 OF4110 Figure 5 FOR BEST PERFORMANCE Cut grass when it is dry. Keep mower blades sharp. Keep mower deck properly levelled. Adjust anti-scalp rollers to prevent scalping. Do not set height of cut too low. For very tall grass, mow twice. Do not travel too fast. Mow with the engine set at full throttle. When mulching, only remove 1/3 of grass length per cutting. Do not cut more than 1 inch (2.54 cm) at any one time. Discharge clippings into areas already cut. Vary cutting pattern with each mowing. Do not allow grass or debris to collect inside of mower deck. Clean after each use. GB - 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

GB - 16
3. Bring the steering levers to neutral.
4. Slow the engine down to about 3/4
speed.
5. Turn ON the PTO switch to engage the
mower.
IMPORTANT:
Never engage the PTO if the
mower is plugged with grass or other
material. This may cause damage to the
electric clutch.
6. Move throttle control to fast.
7. Move the steering levers forward to
obtain a slow ground speed.
8. To disengage the mower, move the PTO
switch to the “Off” position.
9. When you know how to operate the unit,
select a speed appropriate to your
mowing conditions.
PARKING
To park the unit:
1. Bring the steering levers to neutral. Turn
off PTO.
2. Move the throttle lever to the “Slow”
position.
3. Engage the parking brake.
4. Lower the attachment.
5. Turn the ignition key to the “Off” position
and remove the key.
MOVING THE
UNIT WITH THE
ENGINE OFF
IMPORTANT:
Never tow unit.
1. Shut OFF engine.
2. Place seat in the service position (See
Service Position
on page 18).
3. Pull the right and left bypass levers to
the neutral position.
4. Disengage parking brake.
5. Push unit to desired location.
6. Engage parking brake.
7. Push the right and left bypass levers to
the drive position.
FOR BEST PERFORMANCE
Cut grass when it is dry.
Keep mower blades sharp.
Keep mower deck properly levelled.
Adjust anti-scalp rollers to prevent scalping.
Do not set height of cut too low. For very tall
grass, mow twice.
Do not travel too fast.
Mow with the engine set at full throttle.
When mulching, only remove 1/3 of grass
length per cutting. Do not cut more than
1 inch (2.54 cm) at any one time.
Discharge clippings into areas already cut.
Vary cutting pattern with each mowing.
Do not allow grass or debris to collect inside
of mower deck. Clean after each use.
WARNING:
Move the steering
control levers slowly and keep the
throttle control lever at slow
speed until you learn how to
operate the unit.
WARNING:
Do not bypass
transmission when on a slope.
OF4105
OF4110
Pull Lever Out to the Neutral Position
Figure 5
Push Lever In to Drive Position