Asko D5436XLS ASKO Design Guide - Page 7

ASKO DISHWASHERS Electrical The electrical supply should be located in an adjacent cabinet. If the supply cannot be located in an adjacent cabinet, it must be located within the shaded area shown in the illustration below. A separate circuit, servicing only this appliance is required. IMPORTANT NOTE: For the outdoor model, a ground fault circuit interrupter (GFCI) is required to reduce the risk of electrical shock. A GFCI is not recommended for use with other models and may cause interruption of operation. Installation must comply with all applicable electrical codes. ELECTRICAL REQUIREMENTS Electrical Supply Service Receptacle 115 VAC, 60 Hz 15 amp 3-prong grounding-type Plumbing The plumbing supply and drain should be located in an adjacent cabinet. If they cannot be located in an adjacent cabinet, they must be located within the shaded area shown in the illustration below. The water supply line should be connected to a hot or cold house supply with an easily accessible shut-off valve between the supply and the unit. Installation must comply with all applicable plumbing codes. PLUMBING REQUIREMENTS Water Supply Pressure 1/4" OD copper, braided stainless steel or PEX tubing 4.2-140 psi (.3-9.7 bar) OPENING WIDTH 53/8" (137) AREA EXTENDS 2" (51) FORWARD ON FLOOR Electrical supply location. OPENING WIDTH 53/8" (137) AREA EXTENDS 2" (51) FORWARD ON FLOOR Water supply and drain location. askona.com/specs | 7