Asko D5536XLFI Installation instructions EN - Page 7

Step 1. Fitting The Dishwasher In Place

Get Asko D5536XLFI PDF manuals and user guides View all Asko D5536XLFI manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

STEP 1. FITTING THE DISHWASHER IN PLACE 1. Be sure to remove the transport protection for the door when unpacking the dishwasher. 2x 2. Attach the light shielding film (packed in the document bag) to the underside of the countertop above the touch buttons. (Only certain models). 1 ! The light shielding film ensures optimal button functionality. NOTE: The surface on which the protective film is to be attached must be clean and dry. 3. Attach the supplied door sealing (only certain models). 1 This strip is an essential part of the Turbo Dry Express system and must be installed to ensure an optimum seal between the dishwasher tank 2 2 and door. 4. Start by measuring the height from the floor to the bottom edge of the counter top. Measure the height from the floor to the top edge of the dishwasher. 5. Loosen the lock nuts on the dishwasher's steel feet using a 5/8 inch (16 mm) open-ended wrench. Screw the lock nuts down as close to the floor as possible. 5/8" (16 mm) CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
7
STEP 1. FITTING THE DISHWASHER IN PLACE
1.
Be sure to remove the transport protection for the
door when unpacking the dishwasher.
2x
2.
Attach the light shielding film (packed in the
document bag) to the underside of the countertop
above the touch buttons. (Only certain models).
!
The light shielding film ensures optimal button
functionality.
NOTE:
The surface on which the protective film is to be
attached must be clean and dry.
1
3.
Attach the supplied door sealing
(only certain models).
This strip is an essential part of the Turbo Dry
Express system and must be installed to ensure
an optimum seal between the dishwasher tank
and door.
1
2
2
4.
Start by measuring the height from the floor to the
bottom edge of the counter top. Measure the height
from the floor to the top edge of the dishwasher.
5.
Loosen the lock nuts on the dishwasher’s steel
feet using a 5/8 inch (16 mm) open-ended wrench.
Screw the lock nuts down as close to the floor as
possible.
5/8" (16 mm)
CUSTOMER CARE CENTER 1-800-898-1879
• WWW.ASKONA.COM