Asko DBI364IS Instructions for use - Page 30

Troubleshooting

Get Asko DBI364IS PDF manuals and user guides View all Asko DBI364IS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Troubleshooting Error messages F10 Overfilling water 1 F11 Water outlet fault F12 Water inlet fault 1 F40 Inlet valve leakage F41 Heater fault 1 F45 Diverter fault F52 Water level fault F54 Overfilling water 2 F56 Circulation pump fault F67 Water inlet fault 2 F68 BLDC drain pump fault Action Unblocking the drain pump. See the chapter Care and maintenance instructions. If the problem persists, contact your nearest Customer Care Center. See "Water remains in the dishwasher above the filters" under "Problem" in the table below. If the problem persists, contact your nearest Customer Care Center. Check that the water supply valve is on. If the problem persists, contact your nearest Customer Care Center. The water pressure should be 4.2-140 psi. Turn off the water supply valve and contact your nearest Customer Care Center. Turn off the water supply valve. Remove the plug from the power outlet and contact your nearest Customer Care Center. Contact your nearest Customer Care Center. Clean the coarse and fine filters. If the problem persists, contact your nearest Customer Care Center. Turn off the water supply valve and contact your nearest Customer Care Center. To avoid water leakage outside the dishwasher, do not remove the plug from the power outlet until the water supply valve has been turned off! Contact your nearest Customer Care Center. Check that the water supply valve is on. If the problem persists, contact your nearest Customer Care Center. The water pressure should be 4.2-140 psi. See "Water remains in the dishwasher above the filters" under "Problem" in the table below. If the problem persists, contact your nearest Customer Care Center. Press any button to clear the error message. Problem Possible causes Action The control panel does not react You have pressed the control Wait a moment then try again. when pressed. panel too soon after opening the door. Child lock or Automatic child See the chapter Important safety lock is activated. instructions. Dirt on the control panel. Clean with a dry or slightly damp cloth. 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Action
Error messages
Unblocking the drain pump. See the chapter
Care and
maintenance instructions
. If the problem persists, contact your
nearest Customer Care Center.
Overfilling water 1
F10
See "Water remains in the dishwasher above the filters" under
"Problem" in the table below. If the problem persists, contact your
nearest Customer Care Center.
Water outlet fault
F11
Check that the water supply valve is on. If the problem persists,
contact your nearest Customer Care Center.
Water inlet fault 1
F12
The water pressure should be 4.2-140 psi.
Turn off the water supply valve and contact your nearest Customer
Care Center.
Inlet valve leakage
F40
Turn off the water supply valve. Remove the plug from the power
outlet and contact your nearest Customer Care Center.
Heater fault 1
F41
Contact your nearest Customer Care Center.
Diverter fault
F45
Clean the coarse and fine filters. If the problem persists, contact
your nearest Customer Care Center.
Water level fault
F52
Turn off the water supply valve and contact your nearest Customer
Care Center.
Overfilling water 2
F54
To avoid water leakage outside the dishwasher, do not remove
the plug from the power outlet until the water supply valve has
been turned off!
Contact your nearest Customer Care Center.
Circulation pump fault
F56
Check that the water supply valve is on. If the problem persists,
contact your nearest Customer Care Center.
Water inlet fault 2
F67
The water pressure should be 4.2-140 psi.
See "Water remains in the dishwasher above the filters" under
"Problem" in the table below. If the problem persists, contact your
nearest Customer Care Center.
BLDC drain pump fault
F68
Press any button to clear the error message.
Action
Possible causes
Problem
Wait a moment then try again.
You have pressed the control
panel too soon after opening the
door.
The control panel does not react
when pressed.
See the chapter
Important safety
instructions
.
Child lock or Automatic child
lock is activated.
Clean with a dry or slightly damp
cloth.
Dirt on the control panel.
30
Troubleshooting