Asko DBI663ISSOF Use and Care Guide - Page 19
Activate the Extra Dry option.
View all Asko DBI663ISSOF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Problem Possible causes Action "Program paused" is shown on the display. The dishwasher door has been opened while a The dishwasher door must not be open while a program is in progress. program is in progress according to UL Standards. If you want the dishwashing program to continue, press Start/Stop and close the door within five seconds. If you want to cancel the dishwashing program, press and hold the main power switch until the display turns off. Water remains in the dishwasher above the filters. The filters are blocked. Clean the coarse and fine filters. The filters are not fitted correctly. Check that the filter handle is locked in the stop position. The handle should point straight out from the dishwasher. Debris in the drain pump. Clean the drain pump. See the chapter Care and maintenance instructions. Kink in drain hose. Check that the hose is free from kinks and sharp bends. Blocked drain hose. Loosen the drain hose from where it terminates. Check that no debris has clogged the hose. Is the cone-shaped part of the drain boot cut to the maximum size of the fitting where it attaches? Bad odor in dishwasher. Dirt around the seals and in corners. Clean with dish brush and low foaming cleaner. Low temperature programs have been selected Run a program with a higher temperature once for a prolonged period. or twice a month. Or run a self-cleaning program. See Self-cleaning in the chapter Using the dishwasher. The dishwasher is connected to a garbage disposer. Cleaning the garbage disposer connected to the dishwasher can eliminate odors. Follow the disposer manufacturer's cleaning instructions. The dishes are not dry enough. Depending on the load, the program's drying Activate the Extra Dry option. cycle may be insufficient. The dishwasher is not fully loaded. Fully load the dishwasher. Rinse aid needs topping up or dosage is set too Top up with rinse aid or increase the rinse aid low. dosage level. See the chapter Settings. The TAB setting is activated and all-in-one Switch all-in-one detergents or deactivate the detergent with insufficient drying effect is being TAB setting and top up with salt and separate used. rinse aid. See Rinse aid in the chapter Settings. Open the door a little once the program has finished. 19