Asko DFI664 Use and Care Guide - Page 20
Installation instructions
View all Asko DFI664 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation instructions [''] 47 1/8 24* 22 27 1/2 26 3/4 - 30** 32 1/4 - 34 3/8 5 1/8 - 7 3/8 2 1 1/8 - 3 3/4 * If European widths of 23 5/8'' (600 mm) is required, remove the trim kit. **Door length. Nominal dimensions. Actual measurements may vary. It is important that you read through and follow the instructions and directions below. Conduct installation and connection in accordance with the separate installation instructions. Important safety instructions • Connections to electricity, water, and drainage must be performed by a qualified professional. • Always follow applicable regulations for water, drainage, and electricity. • Take care during installation! Wear protective gloves! There must always be two people! • Place a drip tray on the floor beneath the dishwasher to prevent damage from any water leaks. • Before screwing the dishwasher into place, test the dishwasher by running the Rinse and hold program. Check that the dishwasher fills with water and drains. Also check that none of the connections leak. WARNING! Turn off the water supply when installing the dishwasher! The plug must be disconnected or power to the outlet turned off while installing the dishwasher! Setup • The recess and connection dimensions are included in the separate installation instructions. Check that all dimensions are correct before starting the installation. Note that the height of the integrated door panel can be adjusted to match other fittings. • [''] 32 1/4 - 34 1/2 The electrical and water supplies should enter through the area indicated by the shading on the illustration. 24 2 5 3/8 24 4 • Make sure the area on which the dishwasher is to be installed is firm. Adjust the adjustable feet so that the dishwasher is level. Tighten the lock nuts. NOTE! Framed cabinets require additional finished filler material behind the face frame for a proper installation. A minimum 3½" (89 mm) finished return is required on all sides of the opening. 3½" ¾" Frameless cabinetry 3½" Filler Framed cabinetry 20