Asko T411VDT Use and Care Guide English - Page 16

See the separate installation instructions included in the set of documents. CONNECTING TO THE POWER MAINS After installation, the dryer should stand still for two hours before it is connected to the power mains. Connection upon delivery TYPE: TDXX.XXXXX MODEL: XXXXXX.X Art.No.: XXXXXX/XX Ser.No.: XXXXXXXX XXX V ~ XXXX W X kg XXA IPX4 XX Hz Connect the appliance to a grounded power outlet. After installation, the wall outlet should be freely accessible. The outlet should be fitted with a ground contact (in compliance with the relevant regulations). The receptacle on the rear of the machine is designed to accommodate ASKO washers ONLY (rated 208-240 V.) To use this receptacle, you must use the ready-fitted plug supplied with the washing machine or an equivalent. ASKO washers rated 208-240 V have two internal fuses of 15 A each. The machine should only be connected to a grounded wall socket. Information about your dryer is indicated on the rating (type) plate. Use the type A differential current protection switch. The dryer shall not be connected to the power mains using an extension cord. Do not connect the tumble dryer to an electrical outlet intended for an electric shaver or hair dryer. Any repair and maintenance pertaining to safety or performance should be done by trained experts. This appliance must be properly grounded. Refer to the "Important Safety Instructions" for grounding instructions. The power supply cord must be grounded. If the machine is to be used in a wet area, the supply must be protected by a residual current device. Connection to a permanently wired supply point must be made only by a qualified electrician. 16 Customer Care Center, 1-800-898-1879, www.askona.com