Asko T743C User manual 80 891 30 ASKO T743C AE - Page 22
Asko T743C Manual
View all Asko T743C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installation instructions Condensed water Install the dryer so the condensed water will continuously flow into a drain or sink. To do this, follow the instructions below: 1. Connect the rubber hose supplied with the dryer to the blue nipple. 2. Run the hose to a drain or sink, as illustrated. The drain hose must not be more than 40" above the floor. 1 2 Maximum height 40" 2a Electrical installation WARNING! The receptacle on the rear of the machine is designed to accommodate ASKO washers ONLY (rated 208-240 V.) To use this receptacle, you must use the ready-fitted plug supplied with the washing machine or an equivalent. ASKO washers rated 208-240 V have two internal fuses of 15 A each. The machine should only be connected to a grounded wall socket. WARNING! This appliance must be properly grounded. Refer to the "Important Safety Instructions" for grounding instructions. The power supply cord must be grounded. If the machine is to be used in a wet area, the supply must be protected by a residual current device. Connection to a permanently wired supply point must be made only by a qualified electrician. As supplied: Single-phase, 230 V, 60 Hz, 2500W heater rating 30 A circuit required 22 Customer Care Center 1-800-898-1879 www.askousa.com