Asko T760 User manual Quick Start Guide T760 - T780 (Quick Start Guide) - Page 2
Quick Start Procedures - overheating
View all Asko T760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
QUICK START PROCEDURES T760/T780 1. Press the Power button to turn on the machine. 2. Load the dryer. 3. Check the lint filter. Clean it, if needed. 4. Check that the door is clear of laundry then close it firmly. (The door won't shut if it's slammed.) 5. Press the button for the desired program (P1-P4). 6. Press Start. The machine will start. UNDERSTANDING THE LED WINDOW The LED window is easy to read and understand. The illustration below explains what each item on the LED window is. Program When you press the Power button, the display toggles between the program numbers and the wash program names, (e.g., Extra Dry, Dry, etc.) PP11 Extra Dry PP22 Dry PP33 Normal Dry PP44 Iron Dry P1 P2 P3 P4 Start Stop Ti m e 23 Program Time When you start a program, the total time the program runs is displayed. As the program progresses, the time remaining displays. The program time toggles between minutes (e.g., 23) and hours (e.g., 1h). Preset Programs Displays the program that is selected/running. Start Indicates that you pressed Start and the program is running. Stop Indicates that the program has ended or that you pressed Stop. The LED window also displays the menus and options available when you customize the preset programs. Refer to your Use and Care Guide for more details. CLEANING THE LINT FILTER Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each load to ensure maximum air flow and prevent possible overheating. To clean the filter, follow the steps below: 1. Grasp the handle and pull it toward you. 2. Remove the filter from the holder by pulling it up. 3. Open the filter and gently brush away any lint. 4. Fold the filter together and return it to the holder on the door. 5. Push the holder in until it snaps into place. NOTE: We recommend that you clean the lint filter after every load. EMPTYING THE CONDENSATION WATER CONTAINER (T780 only) If Model T780 is not installed to pump out the condensed water into a drain or a sink, you should empty the water container every three to five dryer loads, depending on the spin speed you use when you wash the clothes. For example, clothes spun at 800 rpm will have more moisture when you take them out of the washer than clothes spun at 1400 rpm. Therefore, the dryer will have to remove more water. To empty the container, simply pull it out and pour out the water. This water is clean and can be used to water plants. If the container becomes too full, the machine with shut down. To restart the program, empty the container and press Start. It may be a few minutes before the machine starts because it drains the excess water from the sump before it restarts. Simply pull out the container and pour out the water. NOTE: Do not remove the water container while the machine is running. OVERHEATING PROTECTION The dryer has a protection device that shuts the machine off if the temperature becomes too high. Overheating could occur if the lint filter is clogged or if the fan or condenser unit (Model T780) needs to be cleaned. If the dryer shuts off during a program on Model T780, first, make sure the condensation water container is empty. If that isn't the problem, check the lint filter. Lastly, it could be the fan or condenser unit needs to be cleaned. See your Use and Care Guide for instructions on how to clean these items.