Asko T783C User manual 80 830 36 Asko T783C EN - Page 19

Troubleshooting The machine will not start Check • that the door is properly closed. • that the main power switch is on. • that the machine is not programmed to start at a specific time (e.g., 13.30) • that any plug is connected. • that the fuses (circuit breakers) in your house are intact. Flip the dryer breaker off and then back on to make sure. You can not always tell from the outside if the circuit breaker has tripped. • that the overheating cut-off has not been triggered (see below). Overheating cut-off The overheating cut-off shuts off the tumble dryer if the temperature is too high, caused by lint clogging the lint filter, for instance. • Clean the filter. • Check that the condenser is clean. Clean it if necessary. See the "Care and cleaning" chapter. • The overheating cut-off will reset automatically once the machine has cooled down. Drying takes too long • Check that the lint filter and the condenser are not blocked. See the "Care and maintenance" chapter. • Prolonged drying times may also be due to the tumble dryer being located in a confined space or room that is too small, causing the air to become too hot. • Make sure that the tumble dryer has access to more cold air, by opening doors and/or windows, for example. The laundry does not dry, or is too dry • The door has been opened while the program is running, which disrupts the moisture monitoring function. Error messages • If "Max Program Time" appears on the display, the maximum program time has been reached. Read "Drying takes too long" in the "Troubleshooting" chapter to find out what to do. • If "Clean lint filter" appears on the display, clean the lint filter. • If "Clean condenser" appears on the display. See the "Cleaning the condenser" section of the "Care and cleaning" chapter for remedy • If "Thermistor Fault" is shown on the display. Call the Customer Care Center. • Press the Stop button to close error messages. Customer Care Center 19 1-800-898-1879 www.askousa.com