Asko T793C User manual Use & Care Guide Asko T793C EN - Page 24

Installation instructions

Page 24 highlights

Installation instructions Positioning the tumble dryer The tumble dryer can be freestanding or stacked. Remember that the tumble dryer produces heat and should therefore not be located in a room that is too small. If the room is very small, drying will take longer due to the limited quantity of air. Caution! For proper ventilation, the machine should not be installed behind a door. Caution! The vent on the bottom of the front of the dryer must not be blocked by a carpet or rug. Tip! If the unit must be installed behind a door should be louvered. To improve ventilation, the door where the tumble dryer is located should be left open when the dryer is in use. Caution! Any electrical installation should be carried out by qualified professionals. A. Freestanding The tumble dryer can be positioned beside the washing machine. B. Stacked The tumble dryer can be placed on top of a Asko washing machine. To stack the dryer, you need the stacking attachments (foot cups and anti-tip devices) that come with the machine: You will find 2 foot cups in a bag in the drum and 2 anti-tip devices attached to the bottom left corner at the back of the machine. Extension plates can be ordered from your local retailer. C. Built-in ASKO dryers can be installed beneath a cabinet or worktop with a minimum height of 34" (864 mm). There must be a gap of about 1/2" (12 mm) all around the machine, including between the rear edge of the machine top panel and the back wall. The opening width must be at least 24-1/2" (622 mm). The condensing models work best when they have good air circulation. Install the dryer so the condensed water will continuously flow into a drain or sink, you will need a drain outlet behind the unit. The maximum drain height is 40" (1016 mm). Notes The height adjustment for the dryer is 33-1/2" to 34-1/2" (850 mm to 876 mm). Do not raise it higher than 34-1/2" (876 mm). Hole measurements are from center of hole. 24 Customer Care Center 1-800-898-1879 www.askousa.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

Positioning the tumble dryer
The tumble dryer can be freestanding or
stacked. Remember that the tumble dryer
produces heat and should therefore not be
located in a room that is too small. If the room
is very small, drying will take longer due to
the limited quantity of air.
Caution!
For proper ventilation, the machine should
not be installed behind a door.
Caution!
The vent on the bottom of the front of the
dryer must not be blocked by a carpet or rug.
Tip!
If the unit must be installed behind a door
should be louvered. To improve ventilation,
the door where the tumble dryer is located
should be left open when the dryer is in use.
Caution!
Any electrical installation should be carried
out by qualified professionals.
A. Freestanding
The tumble dryer can be positioned beside
the washing machine.
B. Stacked
The tumble dryer can be placed on top of a
Asko washing machine. To stack the dryer,
you need the stacking attachments (foot cups
and anti-tip devices) that come with the ma-
chine: You will find 2 foot cups in a bag in the
drum and 2 anti-tip devices attached to the
bottom left corner at the back of the machine.
Extension plates can be ordered from your
local retailer.
C. Built-in
ASKO dryers can be installed beneath a
cabinet or worktop with a minimum height of
34” (864 mm). There must be a gap of about
1/2” (12 mm) all around the machine, includ-
ing between the rear edge of the machine top
panel and the back wall. The opening width
must be at least 24-1/2” (622 mm). The con-
densing models work best when they have
good air circulation. Install the dryer so the
condensed water will continuously flow into
a drain or sink, you will need a drain outlet
behind the unit. The maximum drain height is
40” (1016 mm).
Notes
The height adjustment for the dryer is 33-1/2”
to 34-1/2” (850 mm to 876 mm). Do not raise
it higher than 34-1/2” (876 mm). Hole measure-
ments are from center of hole.
Customer Care Center
24
1-800-898-1879
www.askousa.com
Installation instructions