Asko T794 User manual 8092859 Asko T794fi EN - Page 26

Installation instructions To connect the exhaust duct to the rear outlet To connect the exhaust duct to the rear outlet, follow the steps below:. 1. Push the duct onto the stub pipe and secure it with a clamp 2. With the duct attached, insert the stub pipe into the hole. It should snap into place. 3. After you push the dryer into place, check for kinks in the duct. NOTE! Excessive duct length and too many bends can impede drying performance. We recommend that you cut off any excess exhaust duct and run the duct with as few bends as possible. Make any necessary bends as gentle as possible. NOTE! Maximum duct length of 60 feet and 4 elbows are allowed. Subtract 4 feet of duct for each 90° elbow. Connecting the exhaust duct to the Left or Right Side Outlet To connect the exhaust duct to the left or right side outlet, follow the steps below: 1. Using a flathead screw-driver, turn the exhaust outlet cover you plan to use to the right or left to align the tabs holding the cover in place. 2. Remove the exhaust outlet cover. 3. Remove the stub pipe from the rear exhaust outlet and place it in the outlet you plan to use. 4. Push the duct onto the stub pipe and secure it with a clamp. 5. With the duct attached, insert the stub pipe into the hole. It should snap into place. 6. After you push the dryer into place, check for kinks in the duct. 7. Use the exhaust outlet cover you removed from the to cover the rear exhaust outlet. WARNING! To reduce the risk of fire, this appliance must be exhausted OUTDOORS or the equivalent. Never cover the end of the dryer stub or exhaust duct with anything to catch lint, except for UL approved vent basket. 26 Customer Care Center 1-800-898-1879 www.askousa.com