Asko W6324 User manual 80 888 22 Asko W6324 EN - Page 25

Troubleshooting Error messages If a fault occurred during the program cycle, an LED will flash next to Start/Stop and the Door Opening button. L2 L3 LL11 L4 After taking the measures described below, turn off the machine to exit error message mode. L1 Overflow Fault 1. Shut off the water tap. 2. See "Drainage error". L2 Water Outlet Fault Check: • that nothing is stuck in the drain hose outlet. • that the drain pump is not blocked by foreign objects. Clean the pump. See the "Care and maintenance instructions" chapter. • that there are no kinks in the drainage hose. After taking action, run the Drain program or press the Door Opening button (key symbol) to empty the machine. If this does not resolve the problem, call the Customer Care Center. L3 Water Inlet Fault Check: • that the tap on the water pipe is open. • that the filter in the machine's fill valve is not blocked. Action: 1. Shut off the water tap. 2. Unscrew the hose. 3. Clean the filter in the machine's fill valve. 4. Screw the hose back on. 5. Turn on the tap. 6. Run the program again to check whether the error has been fixed. 7. If this does not resolve the problem, call the Customer Care Center. L4 Imbalance The machine stops the spin cycle if there is too much imbalance. The washing machine restarts the spin cycle and hopefully the laundry is better distributed in the drum. This procedure can be repeated up to 10 times. If the machine still fails to find a good balance, the program jumps to the next step. The error message requires no action. Customer Care Center 25 1-800-898-1879 www.askousa.com