Asko W6441 User manual General Use & Care Guide EN - Page 10

W6021 OPERATING INSTRUCTIONS WARNING! To reduce the risk of electric shock or injury to persons, read the "Important Safety Instructions" section on page 2 before operating this appliance. THE CONTROL PANEL Door Open Button Press to open the glass door. (Please note that the unit must be at the end of a program to open the glass door.) The door will open automatically once a program is completed. Start Stop Power Indicator Light Glows when the power is turned on. Power Button Press to turn on power to the machine. Temperature Control Turn clockwise to select the wash temperature. Program Control Turn to select a program. (Please note that the dial does not move as the program advances.) Temperature °F 205 175 160 Drain 85 Spin 105 Rinse Hand/ 120 Delicate Wool 140 Programs Stain Heavy Normal Pe r m a press Quick Super quick Start/Stop Button Press to start or stop/ interrupt a program. Super Rinse Button Press to program seven rinses. No Spin/No Drain Press to omit the spin and final drain cycles. 800 RPM Spin Button Press to reduce spin speed from 1200 rpm to 800 rpm. POWER BUTTON The Power button turns the power to the machine on and off. When the power is on, the power indicator light glows red. The power must be on before you can open the door, set the programs or start the machine. START/STOP BUTTON Once you've selected the program and options, press this button to start the washer. To stop the washer during a program, press and hold this button down until the unit stops (about 3 seconds). DOOR OPEN BUTTON The door will open automatically once a program is completed. Pressing this button will open the glass door as long as the power to the unit is on, the machine is at the end of a program, and there is no water in the machine. NOTE: For instructions on how to open the door manually in case of power failure, see page 24. OPTION BUTTONS Super Rinse Press this button to add two rinses. Press the button again to turn this option off. (This option cannot be cancelled after the main wash water has pumped out.) This option is recommended for persons with sensitive skin or allergies. No Spin/No Drain Press this button to omit the spin cycles in all programs along with the final drain. If you select this option, the unit will stop with water in the drum, so you will have to run the Drain program . The door will open automatically after the Drain program is completed. 800 RPM Press this button to reduce the spin speed from 1200 rpm to 800 rpm. This option is for delicate fabrics that should not be spun at high speeds. Note: This option does not apply to the Rinse and Spin programs.) PROGRAM CONTROL KNOB Turn this knob to the desired program. The table on the following page defines each program. TEMPERATURE CONTROL KNOB Turn this knob clockwise to the desired wash temperature. Always refer to the garments' care labels for recommended wash temeratures. Please note that the wash temperature for the Wool Wash and Hand Wash/Delicate programs will not heat higher than 105° F. CANCELLING A PROGRAM To cancel a program after it has started, press and hold the Start/Stop button until the unit stops. If there is water in the unit, you will have to turn the Program Control knob to Drain then press Start. The water will drain and the unit will stop in 30 to 45 seconds. The door will open automatically after the Drain program is completed. Page 10