Asko WMC User manual 8089878 Asko Professional WMC64V EN - Page 29
Water supply connection, Drain outlet connection, Electrical Connections
View all Asko WMC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Installation Water supply connection Since ASKO washers have a built-in heating element, you only need a cold water inlet. The connection should be made by someone who is sufficiently skilled. Use the hose supplied with the washer. (The inlet hose is marked for correct connection.) The water pressure must be in the range 15-146 PSI. A valve should be fitted on the water supply pipe. If a new supply pipe has been installed for the washer, it should be flushed thoroughly to remove any foreign particles that might clog the filter in the fill valve. Drain outlet connection The machine is supplied with the outlet hose already attached. The hose should be extended over a suitable sink edge or drain pipe at a height of 24" to 36" (610 mm to 914 mm) above the bottom of the unit. (The lower height is preferable.) Make sure the hose is not kinked. 24" to 36" NOTE! If the unit is installed on a second storey, follow local building codes. We recommend installing a drip pan. NOTE! If the hose is extended, the internal diameter of the coupling must not be less than ½". WARNING! Do not extend the drain hose higher than 36" (914 mm) from the bottom of the unit. Electrical Connections The machine is delivered ready-fitted with a plug and is intended for connection to an ASKO Dryer, which is equipped with a matching receptacle. The plug supplied with the washer can only be used with an ASKO Dryer. If the washer is used separately or with another dryer, it must be on a separate 208-240 V single-phase circuit. If the machine is to be used in a wet area, the supply must be protected by a residual current device. As supplied: 208-240 V, 60 Hz, 3000 W heating element,16 A fuse required. Customer Care Center 29 1-800-898-1879 www.askousa.com