Asus A8N-E A8N-E English edition user's manual, version E1911 - Page 44
A8N-E Chassis intrusion connector, A8N-E Front panel audio connector
View all Asus A8N-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
11. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. See related BIOS item in page 2-42. +5VSB_MB Chassis Signal GND A8N-E ® CHASSIS (Default) A8N-E Chassis intrusion connector 12. Front panel audio connector (10-1 pin FP_AUDIO) This connector is for a chassis-mounted front panel audio I/O module that supports legacy AC '97 audio standard. Connect one end of the front panel audio I/O module cable to this connector. A8N-E ® FP_AUDIO BLINE_OUT_L BLINE_OUT_R +5VA AGND Line out_L NC Line out_R MICPWR MIC2 A8N-E Front panel audio connector 1-30 Chapter 1: Product introduction