Asus AP100 Jumper Settings - Page 1

Motherboard Jumper Settings for ASUS AP100 Server IMPORTANT: The User's Manual contains important notes. You may use this diagram for reference purposes only after reading the User's Manual completely. BF0 BF1 BF2 BF3 BF0 BF1 BF2 BF3 BF0 BF1 BF2 BF3 BF0 BF1 BF2 BF3 BF0 BF1 BF2 BF3 BF0 BF1 BF2 BF3 BF3 BF2 BF1 BF0 BF3 BF2 BF1 BF0 BF3 BF2 BF1 BF0 Intel Pentium II Processor 450MHz = 4.5x 100MHz 400MHz = 4.0x 100MHz 350MHz = 3.5x 100MHz 333MHz = 5.0x 66MHz 300MHz = 4.5x 66MHz 266MHz = 4.0x 66MHz 233MHz = 3.5x 66MHz 3 2 1 2.0x (2/1) 2.5x (5/2) 3.0x (3/1) 3.5x (7/2) CPU Core:Bus Frequency Multiple 4.0x (4/1) 4.5x (9/2) 5.0x (5/1) 5.5x (11/2) 3 2 1 6.0x (6/1) FS0 FS1 FS2 FS0 FS1 FS2 FS0 FS1 FS2 FS0 FS1 FS2 FS0 FS1 FS2 FS0 FS1 FS2 FS0 FS1 FS2 3 2 1 50MHz 66.8MHz 75MHz CPU Bus Frequency 83.3MHz 100MHz 103MHz 3 2 1 112MHz +5V (NC) PLED KLCK GRND (NC) +5V GRND GRND SPKR 68 68-Pin Wide SCSI 68 34 68-Pin Ultra2 SCSI DIMM Socket 3 (64/72 bit, 168 pin module) DIMM Socket 2 (64/72 bit, 168 pin module) DIMM Socket 0 (64/72 bit, 168 pin module) DIMM Socket 1 (64/72 bit, 168 pin module) Parallel Port Connector ATX Power Connector Single Edge Contact Slot 1 (for Pentium II) Power Supply Fan Power PS/2 M Mouse (top port) PS/2 K Keyboard (bottom) CPU Fan Power USB 1 USB 2 1 (top port) 2 (bottom) KBPWR CPU Thermal Sensor Connector (TRCPU) COM 1 Intel 440BX AGPset FS2 FS1 FS0 BUS Freq. 50-Pin Narrow SCSI Power LED GW Speaker W B 34 Floppy Drive Connector COM 2 (NC) +5V TBLED EXTSMI GRND PRSW +3VSB (NC) RESET GRND LAN RJ-45 (optional) LAN Activity LED Connector (optional) YW RB VW Turbo LED Power Reset SW SW Panel Connectors 1 35 1 35 1 MultiI/O Intel 82558 Ethernet Controller ASUS P2B-(L)S 1.03 Motherboard (optional) Accelerated Graphics Port (AGP) LAN_EN (optional) PCI Slot 4 SBLINK R PCI Slot 3 SCSI_EN Adaptec 7890 SCSI Chipset 1 Adaptec AIC-3860 Chipset 1 SECONDARY IDE PCI Slot 2 PCI Slot 1 ISA Slot 1 ISA Slot 2 Intel PIIX4E BF3 BF2 BF1 BF0 1 PRIMARY IDE Chipset Freq. Ratio BIOS ASUS A97127F Chipset WOL_CON Power (CR2032 3V Lithium Cell) SCSILED Combine CHASSIS Panel IDELED EXTBATT Infrared 2Mbit Flash EEPROM (Programmable BIOS) CHA_FAN Speaker Hardware Monitor KBPWR Disable (Default) 3 2 Enable 1 Keyboard Power Up LAN_EN Disable 123 Enable (Def) Onboard LAN (optional) SCSI_EN Disable 123 Enable (Def) Onboard SCSI SCSI LED Combine Jumper No Jumper=IDE LED Jumper=IDE+SCSI LED Device Activity LED E268