Asus DRW-0804P User Manual for DRW-0804P English and Traditional Chinese Editi - Page 14
Setting the jumper terminals
View all Asus DRW-0804P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Setting the jumper terminals Set the jumpers to configure the device to either master or slave mode before installing it into your computer chassis. The different modes are discussed below. Select your desired mode by placing the jumper cap over the pins. Put the jumper caps properly over the pins to avoid damage to the drive. Jumper terminals Master Mode RESERVED Cover the two pins labeled MA (see illustration) M A to set the drive as a secondary master drive. Select this mode if your computer supports four IDE devices. The computer hard drive is set as Primary Master. PIN 1 Slave Mode Cover the two pins labeled SL (see illustration) to set the drive as a slave device if your computer supports only two IDE devices. If your computer supports four IDE devices, this mode sets your drive as either Primary or Secondary Slave. RESERVED PIN 1 S L Cable Select Mode RESERVED C PIN 1 Cover the two pins labeled CS (see illustration) S if your computer supports a Cable Select (CSEL) signal. You need an exclusive interface cable for this mode. Refer to your computer manual for details. 14 ASUS DRW-0804P DVD±R/RW drive