Asus E35M1-I DELUXE User Manual - Page 24
E35M1-I DELUXE Chassis intrusion connector
View all Asus E35M1-I DELUXE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
6. System panel connector (10-1 pin F_PANEL) This connector supports several chassis-mounted functions. F_PANEL E35M1-I DELUXE PLED PWRBTN +HDLED RESET GND PWR PLEDPLED+ Reset Ground IDE_LEDIDE_LED+ PIN 1 E35M1-I DELUXE System panel connector • System power LED (2-pin PLED) This 2-pin connector is for the system power LED. Connect the chassis power LED cable to this connector. The system power LED lights up when you turn on the system power, and blinks when the system is in sleep mode. • Hard disk drive activity LED (2-pin +HDLED) This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED cable to this connector. The IDE LED lights up or flashes when data is read from or written to the HDD. • Power/Soft-off button (2-pin PWRBTN) This 2-pin connector is for the system power button. • Reset button (2-pin RESET) This 2-pin connector is for the chassis-mounted reset button for system reboot without turning off the system power. 7. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS E35M1-I DELUXE +5VSB_MB Chassis Signal GND E35M1-I DELUXE Chassis intrusion connector 1-14 ASUS E35M1-I DELUXE