Asus M2A-VM HDMI M2A-VM HDMI user's manual - Page 40

4. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4) These connectors are for the Serial ATA signal cables for Serial ATA 3.0 Gb/s hard disk and optical disk drives. The Serial ATA 3 Gb/s is backward compatible with Serial ATA 1.5Gb/s specification. The data transfer rate of the Serial ATA 3.0 Gb/s is faster than the standard parallel ATA with 133 MB/s (Ultra DMA133). If you install Serial ATA hard disk drives, you can create a RAID 0, RAID 1, and RAID 10 configuration through the onboard onboard SB600 controller. M2A-VM HDMI ® SATA4 SATA2 SATA3 SATA1 GND RSATA_TXP4 RSATA_TXN4 GND RSATA_RXP4 RSATA_RXN4 GND GND RSATA_TXP3 RSATA_TXN3 GND RSATA_RXP3 RSATA_RXN3 GND GND RSATA_TXP2 RSATA_TXN2 GND RSATA_RXP2 RSATA_RXN2 GND GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXP1 RSATA_RXN1 GND M2A-VM HDMI SATA connectors Important note on Serial ATA Install the Windows® XP Service Pack 1 before using Serial ATA. • For detailed instructions on how to configure RAID 0, RAID 1, and RAID 10, refer to the RAID manual in the support CD. • If you intend to create a Serial ATA RAID set using these connectors, set the onboard SATA Type item in the BIOS to [RAID controller]. See the page 2-26 for details. 1-28 Chapter 1: Product introduction