Asus M2N-SLI DELUXE GREEN M2N-SLI Deluxe English Edition User's Manual - Page 48
Internal connectors
View all Asus M2N-SLI DELUXE GREEN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
2.7.2 Internal connectors 1. Floppy disk drive connector (34-1 pin FLOPPY) This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive. Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5. M2N-SLI DELUXE R PIN 1 FLOPPY NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. M2N-SLI DELUXE Floppy Disk Drive Connector 2. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Drive jumper setting Single device Two devices Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices. 2-24 Chapter 2: Hardware information