Asus M2N-SLI Deluxe Wireless Edition M2N-SLI Deluxe English Edition User's Man - Page 150

5.4.3 JMicron® RAID Configuration The JMicron® Serial ATA controller allows you to configure RAID 0, RAID 1, and JBOD sets using the external Serial ATA port and onboard JMicron Serial ATA connector. Before creating a RAID set Prepare the following items: • At two HDDs, preferably with the same model and capacity. • A white floppy disk • Microsoft® Windows® OS installation disk (Windows 2000/XP) • Motherboard support CD with JMB363 driver Complete the following steps before you create a RAID set: 1. Install the external Serial ATA hard disk drives (HDDs) on your system. 2. Set the Onboard JMB363 Serial -ATA item in the BIOS to [RAID]. See section "4.4.7 Onboard Devices Configuration" for details. Advanced Phoenix-Award BIOS CMOS Setup Utility Onboard Device Configuration IDE Function Setup Serial-ATA Configuration USB Configuration Onboard 1394 Controller Onboard 1st nVidia LAN Onboard 2nd nVidia LAN Onboard LAN Boot ROM Primary Display Adapter HD Audio Front Panel Support Type JMicron SATAII Controller Serial Port1 Address Parallel Port Address Parallel Port Mode x ECP Mode Use DMA [Enabled] [Enabled] [Enabled] [Disabled] [PCI-E slot] [Auto] [AC97] [RAID] [3F8/IRQ4] [378/IRQ7] [EPP] 3 Select Menu Item Specific Help Press [Enter] to set F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value F5: Setup Defaults Enter: Select Sub-menu F10: Save and Exit 3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration. 4. Create a JMB363 RAID driver disk for Windows® OS installation. See section "5.5 Creating a RAID driver disk" for details. 5. Install the JMB363 driver after the Windows® OS had been installed. 5-36 Chapter 5: Software support