Asus M2N68 SE User Manual - Page 30
M2N68 SE IDE connector
View all Asus M2N68 SE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
3. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133 / 100 / 66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device(s). Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) - Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices. If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the same setting. M2N68 SE PRI_IDE M2N68 SE IDE connector PIN1 NOTE:Orient the red markings on the IDE ribbon cable to PIN 1. 4. Optical drive audio in connector (4-pin CD) This connector allows you to receive stereo audio input from sound sources such as a CD-ROM, TV tuner, or MPEG card. CD M2N68 SE Right Audio Channel GND GND Left Audio Channel M2N68 SE Internal audio connector 1-20 ASUS M2N68 SE