Asus M4A77T SI M4A77T user's manual - Page 32
Asus M4A77T SI Manual
View all Asus M4A77T SI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
3. The onboard IDE connector is for Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your devices: Drive jumper setting Single device Cable-Select or Master Cable-Select Two devices Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray IDE connector (40-1 pin PRI_IDE) • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices. If any device jumper is set