Asus P2-M2A690G User Manual - Page 79

Memory Configuration Memory Configuration Memory Setting: 333MHz-5.0-5-5-15-2T Memclock Mode CAS Latency (CL) TRCD TRP TRAS Command Timing (2T mode) MCT Timing Mode Bank Interleaving Enable Clock to ALL DIMMs MemClk Tristate C3/ATLVID DQS Signal Training Control Memory Hole Remapping [Auto] [Auto] [Auto] [Auto] [Auto] [ 2T] [Auto] [Auto] [Disabled] [Disabled] [Enabled] [Enabled] Select the DRAM Frequency programming method. If Auto, the DRAM speed will be based on SPDs. If Limit, the DRAM spe will not exceed the specified value. If Manual, the DRAMs specified will be programmed regardless Memclock Mode [Auto] Allows you to select the DRAM Frequency programming method. Configuration options: [Auto] [Limit] [Manual] CAS Latency (CL) [Auto] Allows you to select the CAS Latency (CL). Configuration options: [Auto] [3.0] [4.0] [5.0] [6.0] TRCD [Auto] Allows you to select the TRCD. Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK] TRP [Auto] Allows you to select the TRP. Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK] TRAS [Auto] Allows you to select the TRAS. Configuration options: [Auto] [5 CLK] [6 CLK] [7 CLK] [8 CLK] [9 CLK] [10 CLK] [11 CLK] [12 CLK] Command Timing (2T mode) [Auto] Allows you to select the command timing. Configuration options: [Auto] [ 1T] [ 2T] MCT Timing Mode [Auto] Allows you to select the MCT timing mode. Configuration options: [Auto] [Manual] Bank Interleaving [Auto] Allows you to enable or disable the bank memory interleaving. If set to AUTO, the memory will be checked which executes 64 or 128-bits mode. Configuration options: [Disabled] [Auto] Enable Clock to All DIMMs [Disabled] Allows you to enable or disable unused clocks to all DIMMs even memory slots are not populated. Configuration options: [Disabled] [Enabled] ASUS P2-M2A690G 5-21