Asus P5B-MX P5B-MX user's manual - Page 43
IDE connector 40-1 pin PRI_IDE
UPC - 610839140558
View all Asus P5B-MX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
3. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Drive jumper setting Single device Cable-Select or Master Two devices Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices. If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting. R P5B-MX/WiFi-AP PRI_IDE P5B-MX/WiFi-AP IDE Connector ASUS P5B-MX/WiFi-AP 1-31