Asus P5E GREEN Motherboard Installation Guide - Page 53
IDE connector 40-1 pin PRI_EIDE
View all Asus P5E GREEN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
2. IDE connector (40-1 pin PRI_EIDE) The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There are three connectors on each Ultra DMA 133/100 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. ® P5E P5E IDE connector PRI_EIDE NOTE: Orient the red markings (usually zigzag) on the IDE cable to PIN 1. Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100 IDE devices. If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting. ASUS P5E 2-27