Asus P5E3 DELUXE DDR3 1333 2G User Manual - Page 156
RAID Configuration
View all Asus P5E3 DELUXE DDR3 1333 2G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
5.4.4 JMicron® RAID Configuration The JMicron® Serial ATA controller allows you to configure RAID 0, RAID 1 and JBOD sets on the external Serial ATA hard disk drives. Before creating a RAID set Prepare the following items: 1. Two SATA HDDs, preferably with the same model and capacity. 2. A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a USB flash disk drive (Windows Vista) 3. Microsoft® Windows® OS installation disk (Windows XP) 4. Motherboard support CD with JMB363 driver Complete the following steps before you create a RAID set: 1. Install the two external Serial ATA hard disk drives on your system. 2. Set the Controller Mode item in the BIOS to [RAID]. See section 4.5.3 Onboard Device Configuration for details. Advanced Onboard Device Configuration High Definition Audio Front Panel Type J-Micron eSATA/PATA Controller Controller Mode Realtek GigaBit LAN LAN Boot ROM Marvell GigaBit LAN LAN Boot ROM Agere Firewire 1394 Serial Port1 Address BIOS SETUP UTILITY [Enabled] [HD Audio] [Enabled] [IDE] [Enabled] [Disabled] [Enabled] [Disabled] [Enabled] [3F8/IRQ4] Enable or Disable High Definition Audio Controller Select Screen Select Item +- Change Option F1 General Help F10 Save and Exit ESC Exit v02.58 (C)Copyright 1985-2007, American Megatrends, Inc. 3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration. 4. Create a JMB363 RAID driver disk for Windows® OS installation. See section 5.5 Creating a RAID driver disk for details. 5. Install the JMB363 driver after the Windows® OS had been installed. Always install the JMB363 driver before creating RAID sets. 5-44 Chapter 5: Software support