Asus P5KPL-AM User Manual - Page 33
IDE Connector
UPC - 890552664375
View all Asus P5KPL-AM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
4. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices. PRI_IDE P5KPL-AM PIN1 NOTE: Orient the red markings (usually zigzag) on the ID ribbon cable to PIN 1. P5KPL-AM 240-pin IDE Connector If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the same setting. ASUS P5KPL-AM 1-23