Asus P5N-EM HDMI User Manual - Page 41
Speaker connector 4-pin SPEAKER, IDE connector 40-1 pin PRI_IDE
View all Asus P5N-EM HDMI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
3. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for Ultra DMA 133 / 100 / 66 / 33 signal cable. There are three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device(s). P5N-EMHDMI R PRI_IDE P5N-EM HDMI IDE Connector Drive jumper setting Single device Two devices Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133 / 100 / 66 / 33 IDE devices. If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the same setting. 4. Speaker connector (4-pin SPEAKER) This 4-pin connector is for the chassis-mounted system warning speaker. The speaker allows you to hear system beeps and warnings. SPEAKER 1 P5N-EMHDMI R +5V GND GND Speaker Out P5N-EM HDMI Speaker Out Connector ASUS P5N-EM HDMI 1-29