Asus P5N32-SLI SE DELUXE P5N32-SLI SE DELUXE English Edition User's Manual - Page 57
IDE connectors 40-1 pin PRI_IDE, SEC_IDE
View all Asus P5N32-SLI SE DELUXE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
2 . IDE connector(s) (40-1 pin PRI_IDE, SEC_IDE) The onboard IDE connectors are for Ultra DMA (133/)100/66 signal cables. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your devices. Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices. If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting. P5N32-SLI SE Deluxe SEC_IDE PRI_IDE ® PIN 1 P5N32-SLI SE Deluxe IDE connectors NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. ASUS P5N32-SLI SE Deluxe 2-31