Asus P5Q EM User Manual - Page 48
ICH10R Serial ATA connectors [red] 7-pin SATA1-6 - raid
UPC - 610839167241
View all Asus P5Q EM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
3. ICH10R Serial ATA connectors [red] (7-pin SATA1-6) These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10 configuration with the Intel® Matrix Storage Technology through the onboard Intel® ICH10R RAID controller. • These connectors are set to Standard IDE mode by default. In Standard IDE mode, you can connect Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, set the Configure SATA as item in the BIOS to [RAID]. See section 2.3.5 Storage Configuration for details. • Before creating a RAID set, refer to the manual bundled in the motherboard support DVD. • You must install the Windows® XP/Vista Service Pack before using Serial ATA hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is available only if you are using Windows® XP/Vista. • When using hot-plug and NCQ, set the Configure SATA as in the BIOS to [AHCI]. See section 2.3.5 Storage Configuration for details. Connect the right-angle side of SATA signal cable to SATA device. Or you may connect the right-angle side of SATA cable to the onboard SATA port to avoid mechanical conflict with huge graphics cards. right angle side 1-36 Chapter 1: Product introduction