Asus P5Q SE User Manual - Page 49
IDE connector 40-1 pin PRI_EIDE, IDE Connector
UPC - 610839165292
View all Asus P5Q SE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
2. IDE connector (40-1 pin PRI_EIDE) The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Drive jumper setting Single device Two devices Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices. If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the same setting. P5Q SE PRI_IDE P5Q SE IDE Connector Orient the red marking on the IDE ribbon cable to PIN1. ASUS P5Q SE 2-25