Asus P8P67-M PRO User Manual - Page 42
Marvell, Serial ATA 6.0Gb/s connector 7-pin SATA6G_E1 [navy blue] - raid
View all Asus P8P67-M PRO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
GND RSATA_RXN1 RSATA_RXP1 GND RSATA_TXN1 RSATA_TXP1 GND 8. Marvell® Serial ATA 6.0Gb/s connector (7-pin SATA6G_E1 [navy blue]) These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s signal cables. SATA6G_E1 P8P67-M PRO P8P67-M PRO Marvell® SATA 6.0 Gb/s connector • The SATA6G_E1 (navy blue) connector is for data drives only. ATAPI device is not supported. • You must install Windows® XP Service Pack 3 or later versions before using Serial ATA hard disk drives. • When using hot-plug and NCQ, set the Marvell Storage Controller item in the BIOS to [AHCI Mode]. Refer to section 2.5.6 Onboard Devices Configuration for details. • Press + during POST to enter the Marvell RAID utility to create or delete a RAID configuration. • If you want to install a Windows operating system to a RAID configuration created using the Marvell SATA controller, you have to create a RAID driver disk using the motherboard support DVD and load the driver during OS installation. For 32/64bit Windows XP OS, load first the Marvell shared library driver, and then load Marvell 91xx SATA Controller Driver. For Windows Vista / Windows 7 OS, load only the Marvell 91xx SATA Controller Driver. 1-30 ASUS P8P67-M PRO