Asus PRIME H610M-E D4 Users Manual English - Page 11

Chapter 1: Product Introduction Product Introduction 1 1.1 Before you proceed Take note of the following precautions before you install motherboard components or change any motherboard settings. 1.2 • Unplug the power cord from the wall socket before touching any component. • Before handling components, use a grounded wrist strap or touch a safely grounded object or a metal object, such as the power supply case, to avoid damaging them due to static electricity. • Before you install or remove any component, ensure that the ATX power supply is switched off or the power cord is detached from the power supply. Failure to do so may cause severe damage to the motherboard, peripherals, or components. Motherboard overview 5 6 1 4 2 21.1cm(8.3in) KBMS HDMI VGA DP ATX_12V CHA_FAN2 DIGI+ VRM CPU_FAN ATX_PWR 24.4cm(9.6in) DDR4 DIMM_A1 (64bit, 288-pin module) DDR4 DIMM_B1 (64bit, 288-pin module) U32G1_12 5 LGA1700 Place this LAN_USB_914 side towards the rear of the U32G1_34 chassis 4 8 AUDIO 2280 2260 2242 M.2_1(SOCKET3) PCIE SATA 3.0 X4 X M.2_1(SOCKET3) CHA_FAN1 PCIEX16(G4) Ethernet BATTERY 6 3 Super I/O M.2_2(SOCKET3) PCIE SATA 3.0 X2 X Intel® H610 M.2_2(SOCKET3) SATA6G_3 2280 2260 2242 Audio Codec AAFP PCIEX1(G3) SPDIF_OUT COM COM_DEBUG CLRTC USB_56 RGB_HEADER USB_78 SATA6G_1 SATA6G_2 TPM 128Mb BIOS SPEAKER SATA6G_4 F_PANEL 17 15 13 14 12 10 11 9 7 16 Unplug the power cord before installing or removing the motherboard. Failure to do so can cause you physical injury and damage motherboard components. The pin definitions in this chapter are for reference only. The pin names depend on the location of the header/jumper/connector. ASUS PRIME H610M-E D4 1-1